GS1900-24E - no Webgui after firmware upgrade
Hi,
GS1900-24E is not responding to Webgui after firmware upgrade (C0\GS1900-24E-2.40(AAHK.2)C0.bix)
I updated via Webgui with HTTP method. After some time the Gui offered rebooting, which I confirmed.
After that the webgui is not reachable any more. I tried the static ip address as well as 192.168.1.1 with no success. DHCP is also no registering that device.
Then I tried ZON, but that can't detect the switch either.
Basic switching functionality is working, as connected devices get an active gigabit link and can exchange data.
What about the buttons and jumpers on the PCB?
S1 is the front switch (reset)
S2 is a hidden switch to the side (reachable from the left side through a air vent hole)
T1 is a jumper on the PCB
Do these things help to re-animated the management?
Any idea how to proceed?
Comments
-
Haaah,
already got it.
Found the gui with a IP scanner. The switch changed setting to DHCP and got .55!
So I was able to access it and set the new (correct) static address.
0 -
Hi @GuntherN
Welcome to Zyxel community.
Zyxel switch will firstly try to use DHCP as management if the switch is factory default or reset to factory default. If DHCP is not available, the switch will then go as fixed IP 192.168.1.1.
Glad that the issue is resolved.
Zyxel_Lucious
0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight