How I can setup the DHCP on USG 1100. Firmware 4.33(AAPK.0)
I'm , new on the Zyxel world, I had almost a month try to make work the USG 1100, so far I was able to make the VPN connect but not traffic in and out then I notice that my DHCP is not leasing IP address to no one. If so one can help me to figure this out I will really appreciated.
All Replies
-
Hi @iojeda
In default configuration Ge3~Ge5 have enabled DHCP server function.
Configuration > Network > Interface > edit interface configuration setting.
According to VPN question, system will auto route traffic in the VPN tunnel when traffic SourceIP/DestinationIP are the same as LocalPolicy/Remote Policy in VPN setting.
Does your traffic has match to this condition?
0 -
Thanks for the answer the issue was the firmware, After reset to factory the DHCP start tu issue IP address.
0 -
Hi @iojeda
It's good to know the issue has resolved in your environment.😁
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight