Basic configuration. LAN1 -> WAN interface to go online
Best Answers
-
Remove the static route you don't need that.
The enabled default SNAT should of covered this its in network> interface> trunk default WAN trunk > advance
so try this go to network > routing > policy route
add
incoming: interface
please select one member : Lan1
next-hop
type: interface
interface: wan1
address translation
source network address translation: outgoing-interface
6 -
Thanks for the help, I tried to configure it in this way and it works correctly.0
All Replies
-
Remove the static route you don't need that.
The enabled default SNAT should of covered this its in network> interface> trunk default WAN trunk > advance
so try this go to network > routing > policy route
add
incoming: interface
please select one member : Lan1
next-hop
type: interface
interface: wan1
address translation
source network address translation: outgoing-interface
6 -
Thanks for the help, I tried to configure it in this way and it works correctly.0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight