How to Route only one FQDN (tv.yousee.dk) through WAN2 (USG60W) - Policy Route
Options
I have two Internet Connection WAN1 (Fast) - WAN2 (Slow -but with television streaming)
All traffic must go through WAN1 (Fast) except for tv.yousee.dk (television streaming) which is required when streaming.
My failover to WAN2, if WAN1 is disconnected, works fine.
I have tried different Policy Routes without luck.
Any suggestions?
All traffic must go through WAN1 (Fast) except for tv.yousee.dk (television streaming) which is required when streaming.
My failover to WAN2, if WAN1 is disconnected, works fine.
I have tried different Policy Routes without luck.
Any suggestions?
0
Comments
-
Hi @Kristian,
Do you add a policy route for "tv.yousee.dk" traffic and move to priority one? the configuration as below,
SRC=Lan , DST = tv.yousee.dk IP address 80.62.121.94.
If it is still not work as expected, please post the this CLI result.
Router> show policy-route
1 -
Bingo! It works!
But I think I did the same, but probably not.
You are todays hero ;-) Thank You :-)
0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 87 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 916 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight