no radius traffic coming from ap and controller
Options
syure_p
Posts: 4
Hi,
I'm having challenges getting an external radius authentication setup working with the Zyxel. All the devices are
terminating to the same switch and are on the same VLAN allocated for management. There is full connectivity between the devices as well.
However, there seems to be no radius request coming from the AP and controller. Debug from the radius does not show any packet coming in and on pcap from the switch does show any radius auth/acct traffic as well.
I have upgraded the firmware and tried several configuration combination on the security section but the issue remains - no radius traffic coming out from the AP/ controller.
Please refer to the attached screenshots of the controllers AP, Security and WLAN configuration
Below is a high-level diagram depicting how the device involve are interconnected.
I'm having challenges getting an external radius authentication setup working with the Zyxel. All the devices are
terminating to the same switch and are on the same VLAN allocated for management. There is full connectivity between the devices as well.
However, there seems to be no radius request coming from the AP and controller. Debug from the radius does not show any packet coming in and on pcap from the switch does show any radius auth/acct traffic as well.
I have upgraded the firmware and tried several configuration combination on the security section but the issue remains - no radius traffic coming out from the AP/ controller.
Please refer to the attached screenshots of the controllers AP, Security and WLAN configuration
Below is a high-level diagram depicting how the device involve are interconnected.
0
All Replies
-
Hi @syure_p ,
From the attachment that you provided, you used Open+Enterprise in the security list. According to the authentication behavior, Open+Enterprise is used for Windows XP or the third-party utility. The OS version after Windows 7 must use security mode as WPA for Enterprise to make it work. If using Open+Enterprise, it will not pop out the credential request to ask you fill in. So, please modify the Security mode to WPA, and let me know if it helps.
Thanks.0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 87 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 916 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight