Usg vpn site to site UP but not working
Options
Comments
-
Following some guides found on Internet is probably not a very good starting point: why not simply start with official ZyXEL KB Articles as foundation for your configurations? it's the path I personally prefer.
As example:- ZyXEL IPSec VPN Site to Site (Static IP Public addresses) KB Article
- ZyXEL VTI VPN Site to Site (Static IP Public addresses) KB Article <-- if you have both USG with 4.20 or newer you can use VTI instead of more common IPSec approach (useful if you are planning in near/far future to perform VPN tunnel balancing over two WAN interfaces on each side).
0 -
@parnassus, Thanks for your sharing.
Hello Roma123,
I want to confirm that is your topology like
USG110--(VPN connection)---internet---(VPN connection)--USG210?
You can follow the configuration which parnassus shared, and here is the similar example of VPN from FAQ as your reference.
https://businessforum.zyxel.com/discussion/551/an-example-of-site-to-site-vpn#latest
Charlie0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight