[NEBULA] Allowed Remote IP
Options
TCL_Support
Posts: 8 Freshman Member
I am trying to find a good manual that documents everything on the NGG100 gateway but so far have only found the user guide that is good for a general user but not at a network engineering level.
Currently I am trying to find out what I can put in the 'Allowed Remote IP' field under the NAT/Virtual Server rules. A single IP address in their works fine but we need to allow a range of addresses to access an open port, i.e. can we put in 51.140.0.0 to use a range of addresses or does it understand 51.140.0.0./14, etc.?
Currently I am trying to find out what I can put in the 'Allowed Remote IP' field under the NAT/Virtual Server rules. A single IP address in their works fine but we need to allow a range of addresses to access an open port, i.e. can we put in 51.140.0.0 to use a range of addresses or does it understand 51.140.0.0./14, etc.?
0
Comments
-
Hi @TCL_Support
Welcome to Nebula Forum!Yes, 51.140.0.0/14 can be understood! The format of Allowed Remote IP field can be as below; you can select one format to apply.
1. A specific ipv4 address, such as 51.140.0.0
2. A valid IP range, such as 51.140.0.0/14
3. Any: to allow any remote IP
0 -
Ok, perfect - at last a feature that works! Many thanks for the answer.
1
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight