No arpseal activate - permanent
Options
I have a problem with a particular internet service provide that is using these Hitron modems.
When configured for static ip mode, the modems seem to "announce" two MAC address same ip address "Possible arp spoof attack"
Needless to say the ISP is slow to respond. The quick fix is to invoke this command at the command line "no arpseal activate" but my understanding this is temporary.
Is there a way to make this permanent? Or to have it scripted on boot up?
When configured for static ip mode, the modems seem to "announce" two MAC address same ip address "Possible arp spoof attack"
Needless to say the ISP is slow to respond. The quick fix is to invoke this command at the command line "no arpseal activate" but my understanding this is temporary.
Is there a way to make this permanent? Or to have it scripted on boot up?
0
Accepted Solution
-
@dscope
You need tp enter command write to save the CLI:no arpseal activate.Router(config)# no arpseal activateRouter(config)# write
Charlie5
All Replies
-
@dscope
You need tp enter command write to save the CLI:no arpseal activate.Router(config)# no arpseal activateRouter(config)# write
Charlie5 -
I see. I didn't realize that the parameter setting DOES get saved. For some reason it was mentioned to me that it doesn't.
Thank you very much0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight