ATP200 Hangs on reboot - 2nd device same problem
Options
I have an ATP200 that hangs on reboot. I have to physically power the device off via the power button and then it comes up normally. I have rma'd this device and problem persists even with new hardware. I was hoping a firmware update would fix and also tried a factory reset, but problem continues regardless of firmware. I have a client that I put an ATP100 in and it seems to reboot ok. I have a ticket in, but hoping others have seen this problem.
0
All Replies
-
Hi @iSpeed,
We need to check the console messages in the reboot process to clarify if it is hardware or firmware issue.
I'll contact you in private message to arrange the remote session.
0 -
Just experienced another hang on reboot. I now think it's the content filter that's causing the hang. Yesterday I had a site that was dead. I tried to lookup via test url feature and it returned an error message. I hard powercycled the device after hang and did the same test and content filter returned normal messages.
0 -
Hi @iSpeed,
The firmware is sent to you in private message.
You can follow the guide to collect console messages when the device gets stuck again in the reboot process.
0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight