L2 isolation is not working
Options
Running_MAN
Posts: 2 Freshman Member
I use some APs for my guests to connect and L2 isolation to avoid they can connect to each other when they come to my office.
Recently, I changed my configuration to add captive portal and redirect them for using a QR code to access internet.
But, after I doing the captive portal setting, the L2 isolation is not working.
Shouldn't these two functions use at the same time?
Recently, I changed my configuration to add captive portal and redirect them for using a QR code to access internet.
But, after I doing the captive portal setting, the L2 isolation is not working.
Shouldn't these two functions use at the same time?
0
Comments
-
Hi @Running_MAN
The two function can be use at the same time.
For your application, captive portal must redirect on controller.
You might have encounter the condition like that.
The tunnel mode is not allowed when using layer-2 isolation profile.
You must set
1. Forwarding mode to Local Bridge.
2. Change the topology let the traffic must go through controller to gateway.
For example: WAN-----gateway----NXC---switch---AP ) ) ( ( client
Kathy
1
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 74 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 333 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 198 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight