[NEBULA] Setup NWA1123-ACv2 to repeater mode
All Replies
-
Nebula_Barney said:Hi @Ngoc_Le_VN01
The method involves a default mesh-ID present among all Nebula APs.
Three conditions must be fulfilled for a newly added AP without wired connection to automatically join the Smart Mesh:
1. At least one Nebula AP acting as a root
- Smart Mesh enabled
- Wired uplink port is connected
2. Newly added AP is using latest firmware
3. Newly added AP is added to the same Nebula organization as root AP
When you power-on your new AP without a wired uplink connection, your AP will turn into repeater mode and scan the vicinity for the default mesh-ID. Your root AP will then check if this AP is registered under the same Nebula organization. Once verified, your root AP will allow your new AP to form a mesh and is allowed access in to the local network.
At this point, new AP connects with NCC, receives site-related configurations, and finally connects to the true mesh-ID.
Regards,
Barney Gregorio
Ngoc0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight