Source NAT with SBG
mrc_teleglobal
Posts: 1
Hi,
i'm relatively new to this kind of routers and i' m trying various configurations.
One of this is snat or source nat.
I have a wan configured with a set of ip given by my provider, and another set wich i should use to navigate and publish hosts.
The problem is that i'm unable to publish an host or a port of an host with my public ip.
If i configure the basic the router let me navigate with the wan address which i can't use but with an address mapping i solve the problem.
The problem which i'm facing is the normal port forwarding or snat, because i' m unable to user other than the wan address.
The provider has already created a route for the point-to-point interface ( or wan ) and the public ip which i have bought with the line, nut i'm unable to have a port forwarding with the public pool of ip.
I would like to know if someone had a similar problem and if was able to solve it.
Thanks a lot
Bye
Cristian
0
All Replies
-
@mrc_teleglobal
The Wan interface need to be set PPPoE and tick Fullfeature NAT enable. Next, Go to NAT>Port Forwarding>Create the NAT rule to allow remote user can access local host.
The below example as your reference:
Charlie0
Categories
- All Categories
- 339 Beta Program
- 2.1K Nebula
- 112 Nebula Ideas
- 75 Nebula Status and Incidents
- 5K Security
- 39 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 882 WirelessLAN
- 32 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 325 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 810 Nebula FAQ
- 397 Security FAQ
- 214 Switch FAQ
- 190 WirelessLAN FAQ
- 44 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight