Zyxel NXC 5200 5Ghz
ummka
Posts: 2
Hi,
There is a NXC5200 controller, there are access points at 2.4 GHz / 5 GHz and a few at only 2.4 GHz. The problem is this: the client connected to the 5 GHz point when moving to a zone where only 2.4 GHz the client does not automatically connect to the 2.4 GHz network.0
All Replies
-
Hi @ummka
Could you help to confirm if the SSID of 2.4G is the same as 5G?
Please also help to confirm the 2.4G signal is good to connect or not.
Thanks.
Joslyn
0 -
Of course, SSID 2.4 GHz such as SSID 5 GHz.
The 2.4 GHz signal is very good. When you go from one end of the corridor where there is an access point at 5 GHz to the other end of the corridor where there is an access point at 2.4 GHz, the 5 GHz signal is very weak and disappears, and the 2.4 signal of the access point is excellent, but the client does not automatically switch to it
0 -
Hi @ummka
It seems 2.4G and 5G will be serviced by different APs.
Did you enable the captive portal for the stations? Will the station get the same IP address of 2.4G and 5G?
If possible, please collect the diagnostic when the roaming failed and provide me the topology.
Please send me the information via private message for secure.
Thanks.
Joslyn0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight