2.4G and 5G leds remain amber on my Zyxel nwa1123-ac pro even after correct configuration
Options
Adrian
Posts: 4
Hi, so I've configured my zyxel nwa1123-ac pro and it works just fine, absolutely no problem 'till now. Only thing is, the 2.4G led and the 5G led remain amber(instead of green) and I don't understand why, since it works.
I know it might seem trivial, but I would like to know if maybe I've missed something.
Thanks
I know it might seem trivial, but I would like to know if maybe I've missed something.
Thanks
0
Accepted Solution
-
Hi @Adrian
The LED showed Amber means the antenna switch is set to "Wall" for the radio.
Would you like to check for your antenna setting?
Physical setting.
Software setting.
The antenna switch in the web configuration has priority over the physical antenna switch after you Enable Software Control as the software setting.
Thanks.
Joslyn5
All Replies
-
Hi @Adrian
The LED showed Amber means the antenna switch is set to "Wall" for the radio.
Would you like to check for your antenna setting?
Physical setting.
Software setting.
The antenna switch in the web configuration has priority over the physical antenna switch after you Enable Software Control as the software setting.
Thanks.
Joslyn5 -
Yes, that was it. Thank you very much!0
Categories
- All Categories
- 385 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 908 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 200 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight