[NEBULA] Site-to-Site VPN. Two NSG50 connected and tunnel established but now what?
I have two NSG50 units for a headquarters and branch1. I've established a site-to-site vpn using Nebula. Able to ping headquarters Gateway, AP, and printers on site. Able to access web-interfaces for printers. Was not able to ping target PC at headquarters. Not able to see shared network resources under Network on branch1 PC. What step(s) am I missing in Windows to make this work? Creating security policies and generating certificates?
0
Comments
-
Have you disable the firewall rule on windows? Maybe that's why there is no respond.
As I recall, you cannot find the shared folder in the network neighborhood, since their VPN tunnel doesn't allow broadcast traffic pass through the tunnel.
You can try to access via IP directly.2 -
If I disable the private network firewall I can ping each target PC, map network drives and printers by their IP address. Resolved!
0 -
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 832 Nebula FAQ
- 402 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight