BWM Setting

JOEY
JOEY Posts: 6  Freshman Member
Friend Collector First Comment
edited April 2021 in Security
Hi,

Im using USG310 to connect a point-to-point lease line  and would like to setup BWM to control the bandwidth.
there is 2 VOIP device on both site i setup to below BWM configuration

I have some question on bandwidth shaping.  The local VOIP has 2 way traffic (in/out). 
so, if i want to limited the bandwidth to 1.5 MB and give highest priority on this device.
What is the setting on Bandwidth Shaping ?

My current setting like below:-
Criteria
Incoming interface GE1(the port plugged Lease line), 
outgoing interface GE8 (the port plugged VOIP)
Source: (the IP address of the remote site)
Destination: (IP address of local voip)

Bandwidth Shaping
Guaranteed Bandwidth: 
Inbound: 768 kbps, Priority: 7
Outbound: 768 kbps, Priority: 7

Is it correct ? or create 2 rows of configuration to specific the inbound and outbound traffic ?.
thanks in advance

Comments

  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,426  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Hi @JOEY,
    This BWM rule only applies on connection initialized from GE1 to GE8, it does not have effect on VOIP connection which is initialized from GE8 side (initial connection from lan). You should add one more BWM rule to control connection from GE8 to GE1.
  • JOEY
    JOEY Posts: 6  Freshman Member
    Friend Collector First Comment
    Thanks,  is it mean i create 2 rules, like below:-
    1) GE1 to GE8
    Bandwidth Shaping

    Guaranteed Bandwidth:  
    Inbound: 768 kbps, Priority: 7
    Outbound: 0 kbps, Priority: 0
    2) GE8 to GE1
    Guaranteed Bandwidth:  
    Inbound: 0 kbps, Priority: 0
    Outbound: 768 kbps, Priority: 7

Security Highlight