Data loss
lacc47
Posts: 4 Freshman Member
NAS326
I wanted to access my drives so I removed the drives from the nas. It is possible, that I took them back reversed, but It is not probable. Anyway, I cant access my drives. NAS turns off after boot beep. Without the drives it boots and it is accessible, but with the drives it turns always off. How can I repair this error?
There was no raid, it was two independent disk.
thanks
#NAS_Aug_2019
I wanted to access my drives so I removed the drives from the nas. It is possible, that I took them back reversed, but It is not probable. Anyway, I cant access my drives. NAS turns off after boot beep. Without the drives it boots and it is accessible, but with the drives it turns always off. How can I repair this error?
There was no raid, it was two independent disk.
thanks
#NAS_Aug_2019
0
All Replies
-
It doesn't matter when you exchanged the disks. The disks are recognized by their raid header (which is also available on a single disk layout).Try the disks one by one. I think one of them died.0
-
Hi,
Many thanks for answer.
I made factory reset without the disks, and after that the problem is solved, just I lost my configuration. Nas runs up, I can access the disks as befor.
regards
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight