Can't set admin password on NAS542
Options
Kris
Posts: 2 Freshman Member
After HW reset.
1: I'm prompt with login request.
2: I use default admin password and is then asked to make new password.
3: I'm back to login page. But my new password i rejected. I can use default password. Then back to 2
I found this question in an earlier thread, but I couldn't find an usable answer.
Any ideas how to proceed?
#NAS_May_2019
1: I'm prompt with login request.
2: I use default admin password and is then asked to make new password.
3: I'm back to login page. But my new password i rejected. I can use default password. Then back to 2
I found this question in an earlier thread, but I couldn't find an usable answer.
Any ideas how to proceed?
#NAS_May_2019
1
All Replies
-
I remember vaguely that I have read about this. Someone had a problem with passwords in the webinterface, and after debugging the webinterface he found that his virusscanner/firewall was responsible for intercepting his actions.
0 -
I have the same problem. Full reset helped.0
Categories
- All Categories
- 393 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 906 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight