Allowed WTP number is FULL
Options
I get the following error when trying to add another AP to the managed list.
Allowed WTP number is FULL
Interesting is that I used to have both AP configured within the USG40 I'm not sure what even happened.
Both AP Models are: NWA5123-AC
Thank you
- Justin
Allowed WTP number is FULL
Interesting is that I used to have both AP configured within the USG40 I'm not sure what even happened.
Both AP Models are: NWA5123-AC
Thank you
- Justin
0
Comments
-
I guess I should add that this facility is only using two AP's. Device is suppose to allow 2 AP's to be controlled out of the box. Why is it only allowing for one?
I am running the lasted Firmware v4.30(AALA.0)0 -
@PITS,
I want to confirm the information with you first, so could you screenshot the license page for checking.
Please private message the configuration to me.Since I tested locally, I cannot reproduce your issue.
Also, to analyze this case, could you remove the added APs, and do the steps again. Add the first AP to the list and then add the second AP to see does the issue occur again.
Charlie0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 79 Nebula Status and Incidents
- 5.1K Security
- 70 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 885 Nebula FAQ
- 415 Security FAQ
- 226 Switch FAQ
- 198 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight