Hot fix for CVE-2020-29583 is available now
Zyxel_Dick
Posts: 21 Zyxel Employee
Comments
-
We've tried updating our NXC2500 from V6.10(AAIG.0) to V6.10(AAIG.1) two times. In both cases the controller does not boot after the update. The SYS led is red. After a power cycle the controller still works, but the firmware is reverted to the old version V6.10(AAIG.0). Any tips?0
-
Hi @RhvO ,
May I know is there any log shown in NXC2500 about the firmware upgrade failed? Would you collect the diagnostic and PM to me to check the detail of the upgrading issue?
Thanks.0 -
Hi @RhvO
Would you mind to upgrade the firmware via FTP which will transfer the firmware image faster? Enable the FTP service for this time, and follow the below steps to upgrade the FTP firmware.
After finishing updating, disable the FTP service if you are worried about the impact.
Joslyn0 -
Thank you for help. We do not get any information in the logs. We will try the ftp method.0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 830 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight