[NEBULA] Band Select

Cham
Cham Posts: 3  Freshman Member
First Anniversary
edited April 2021 in Nebula
What are your experiences with the Band Select feature.?

Personally when i turn it on, i have a really hard time to connect to 5ghz (Concurrent operation same SSID)

Comments

  • Zyxel_Dean
    Zyxel_Dean Posts: 237  Zyxel Employee
    First Anniversary Friend Collector First Answer First Comment
    Hi @Cham

    This feature only blocks 2.4Ghz association requests, it could be possible for the client to have a hard time to connect if it perfers sending requests from 2.4Ghz radio first. What client device are you using?


  • HealthByRo
    HealthByRo Posts: 28  Freshman Member
    First Comment
    So does turning the "Band Select" off help with Macbooks connecting to 5GHz band when both bands are on the same SSID?
  • Zyxel_Dean
    Zyxel_Dean Posts: 237  Zyxel Employee
    First Anniversary Friend Collector First Answer First Comment
    Hi @HealthByRo

    The Band-Select feature delays the 2.4Ghz clients response to encourage the use of 5Ghz, it does not have impact over clients that already are connecting by 5Ghz.
    Turning ON should help devices connect to 5Ghz, turning OFF will let the device connect as it prefers. 
    So the answer to your question is, no effect.

    Macbooks normally prefers 5Ghz on the initial connection so under normal conditions this feature does not have influence. Unless 5Ghz signal is too bad and the Macbook initially uses 2.4Ghz to try connect, turning OFF band select will improve the connection but this connection will be on 2.4Ghz.



Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）