Zywall 100 lost configuration
After power off my Zywall 100 lost last configuration and start with "last good". Because always after some changes I save config I try start Zywall with backup config: Zywall find some problems in it and back to "last good". How can I check what is wrong in this config?
0
All Replies
-
Hi @Leszek,
Connect the serial console between ZyWALL and one laptop.
Use the commands to apply your backup configuration file.
If it failed to apply the backup configuration file, you'll find the reason in "ERROR:".
Router# configure terminal
Router(config)# apply /conf/test_backup.conf
0 -
Hiwe tested it and finally there was no error on the terminal but new config did not load. There was a additional restart during loading new config and Zywall had old one "last good".But we found a solution: we use the load via HTTP with option "...ignoring errors" and it's working.
1
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 832 Nebula FAQ
- 402 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight