vpn site to site

damianodec
damianodec Posts: 42  Freshman Member
First Anniversary Friend Collector First Comment
edited April 2021 in Security
hi,
I need a VPN site to site, site A and B have USG40.
site A 192.168.6.x and USG40 192.168.6.254
site B 192.168.6.x and USG40 192.168.6.1

is it possible or have I to change addresses on A or B ?

thank you

All Replies

  • Alfonso
    Alfonso Posts: 257  Master Member
    First Anniversary Friend Collector First Answer First Comment
    Hi @damianodec

    I do not think you can establish a VPN using yje same source and destination ip address range (I am assuming network netmask is /24).
    If ip address range of the sites are not overlapped, the VPN be configured.

    Another way to try to connect is to configure static NATs which will be done in (for example) in site A, and "undone" in site B. But i do not recommend it. 

    Regards

     
     
  • Jeremylin
    Jeremylin Posts: 166  Master Member
    First Anniversary First Answer First Comment

    Check this article to avoid local subnet overlapping problem. 

    However, it could be managed easier if the network with different subnet. 

    https://kb.zyxel.com/KB/searchArticle!viewDetail.action?articleOid=014715&lang=EN


  • PeterUK
    PeterUK Posts: 2,655  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer

    If you subnet each site to 255.255.255.128 then it would work.


  • serverpal
    serverpal Posts: 29  Freshman Member
    First Anniversary Friend Collector First Comment
    thank you!

Security Highlight