USG 60 current temperature
Hi everyone!
I have USG 60 with firmware V4.35(AAKY.2). It seems to me firewall is too hot. How can i see current temperature of the device? Temperature doesn't monitor in dashboard or logs (perhaps i didn't notice it). And i couldn't find any right commands to watch it in CLI mode.
thanks!
All Replies
-
Go to console, and type the CLI: Router# debug hardware fan-get.
You will see the current temperature of Device.
However, if the device is quite hot, you should place the device in ventilated environment.
Charlie
0 -
Device give an error: parse error/command not found. I guess, my usg does not support this command.0
-
I think you go to the wrong level to type this command.
After you login, you enter this command directly.
0 -
No, it doesn't work anyway. There's same error. I have attached screen with error and command list of debug mode. This list is not contain "fan-get".
0 -
The CLI: "debug hardware fan-get" only on USG110 and above series can check it. It depends on the hardware platform's design.
0
Categories
- All Categories
- 383 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 890 Nebula FAQ
- 415 Security FAQ
- 233 Switch FAQ
- 203 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight