IPSec VPN to Azure
Hi, I am using USG20W-VPN device and using a dynamic public IP. I want to create a site to site VPN to Azure. I followed the procedures in the article described :
How to Configure Route-based IPsec VPN to Azure (VTI over IKEv2/IPSec)
But its not working. Can somebody help me.
Thanks in advance
All Replies
-
Hello SecureShell,
When you completed the setting, the issue you encounter was;
1) VPN tunnel can build up successfully, but cannot ping to Azure virtual network host.
or
2) Just VPN tunnel build up fail?
The way to trouble both case is different.?
0 -
Hi Lalaland,
Thanks for your response.
I checked and found that the tunnel has been established, but I couldn't find any place at Zyxel console to find that information. I could only see this at Azure on Virtual Network Gateway (connected). I should have checked there first before making this post!
Thanks anyway.
0 -
Hi @SecureShell
You may use "show sa monitor" in the console to realize the tunnel connection status
0
Categories
- All Categories
- 383 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 890 Nebula FAQ
- 415 Security FAQ
- 233 Switch FAQ
- 203 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight