Trouble go from 433AAAA0ITS-WK30-r89425 to V4.35

Options
PeterUK
PeterUK Posts: 2,756  Guru Member
First Anniversary 10 Comments Friend Collector First Answer
edited April 2021 in Security

It even failed when going back to V4.33 so had to load the config with “Ignore errors and finish applying the configuration file” then load V4.35. Should anyone else have the same issue

So all working including my USG40/60 that upgraded fine.

Noticed the new source IP in NAT sure some will make use of that, was hoping for other added bits so waiting for them.


Comments

  • Zyxel_Emily
    Zyxel_Emily Posts: 1,296  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Options
    Hi @PeterUK,

    In our lab, there is no problem upgrading ZyWALL110 from 433AAAA0ITS-WK30-r89425 to 4.35.

    The firmware 4.35 is uploaded to the standby partition.

    ZyWALL110 reboots successfully with the startup-config.conf.

    Here is the whole process of firmware upgrading for your reference.

    https://www.dropbox.com/s/9ilrrzl9u7opo1x/435.wmv?dl=0

     

    If you still get problem with upgrading from 4.33WK30 to 4.35, please share the configuration file with us to check the symptom.

  • PeterUK
    PeterUK Posts: 2,756  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited October 2019
    Options

    You might have had no problem but I did, something in the config it didn't like but like I said I loaded V4.33 which also didn't like my config till I loaded my config by “Ignore errors and finish applying the configuration file” then V4.35 loaded fine.

    So all fine now


Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）