Zywall 110 - Netbios names
Options
Upgraded firmware from 3.10(AAAA.1) to 4.30(AAAA.0). When I go to ping a NetBIOS name from LAN1_SUBNET to another computer on LAN1_SUBNET, the Zywall is resolving the name to a dead address.
ping john
"Pinging john.ZyXEL-USG [198.105.244.117] with 32 bytes"
Any ideas what I need to change to get the Zywall to recognize computer names and serve addresses correctly?
ping john
"Pinging john.ZyXEL-USG [198.105.244.117] with 32 bytes"
Any ideas what I need to change to get the Zywall to recognize computer names and serve addresses correctly?
0
Comments
-
Hello Adam,
For this case,
according to windows mechanism, since the both PCs are in the same subnet, the ping traffic will not flow into gateway.(PCs will communicate with each other directly) Therefore, USG will not control the communication between both of PCs. If ping is not working, please make sure the firewall of PC are turned off.
Moreover, I would like to know the topology of this scenario for check further.
Charlie
0
Categories
- All Categories
- 383 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 887 Nebula FAQ
- 415 Security FAQ
- 231 Switch FAQ
- 201 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight