How to establish VPN Tunnel?
1. Check WAN/LAN status(up) and IP address
(Please make sure the SBG can communication with USG)
2. 「Add New Entry」
3. Check the “Enable” box for IPSec VPNàFill up the “Connection Name”àChoose “Application Scenario”àMy address “ETHWAN”àPrimary Peer Gateway Address(USG WAN IP Address)
4. Setting Pre-Shared Key(The pre-shared must be the same with each other)
5. At the process pre-shared key, phase1&2, all setting should be same with each other!
Phase1: Negotiation Mode(Main)àEncryption(3DES)àAuthentication(MD5)àKey Group(DH2)
6. Phase2: Tunnel Mode(ESP)àEncapsulation(Tunnel)àEncryption(3DES)àAuthentication(MD5)
7. Policy: Setting the Local IP(SBG LAN)/Remote IP(USG WAN)
Note: The Local IP Address must different with Remote IP Address
8. After the setting done, please verify the “Entry” enable and the SBG will take a while to establish the VPN Tunnel with USG
9. You can also check the VPN Tunnel status by Monitor and the status page
Categories
- All Categories
- 383 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 889 Nebula FAQ
- 415 Security FAQ
- 231 Switch FAQ
- 202 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight