What do I do if I forget the administrator password?

Zyxel_JasonZyxel_Jason Zyxel Official Agent Posts: 102  mod
NOTE: The following steps below will reset the configuration to default, please backup the configuration at all times.

For the smart manage devices GS1900 & GS1920 series, please push the "Reset" button for 10 seconds to restore the factory default settings.

The following figures show the front panel reset button of GS1900 series Switch.

Figure 1  Front Panel: GS1900-8


Figure 2 Front Panel: GS1900-8HP
Revision A1


Revision B1


Figure 3 Front Panel: GS1900-10HP


Figure 4 Front Panel: GS1900-16


Figure 5 Front Panel: GS1900-24E


Figure 6 Front Panel: GS1900-24


Figure 7 Front Panel: GS1900-24HP


Figure 8 Front Panel: GS1900-48


Figure 9 Front Panel: GS1900-48HP



The following figures show the side panels reset button of GS1920 series Switch.

Figure 10 Side Panel: GS1920-48


Figure 11 Side Panel: GS1920-24, GS1920-24HP & GS1920-48HP



For the layer 2 and layer 3 managed switch please refer to the following steps:

1. Connect to http://www.zyxel.com/support/download_landing.shtml and download the firmware file of the device.

2. Connect a console cable to the switch.

3. Open Tera term software through the operating system.

4. Power up the switch then enters debug mode.
Figure 12 Debug mode


5. Input the command "atlc" to upload ROM file.
Figure 13


6. Browse and choose the ROM file in the firmware file then upload the ROM.
Figure 14 File > Transfer > XMODEM > Send


7. After the ROM file is successfully uploaded then input the command "atgo" to continuously boot up the device.
Please remember that the baud rate will be changed to 9600.


8. The device is ready to use. Username: admin. Password: 1234.


Jason
Sign In to comment.