USG not comunicate with specified IP address
Options
RaphaelOIiveria
Posts: 35 Freshman Member
Hi,
This is my case.
We have a rang of WAN IPs (Ex: 192.168.0.96-255.255.255.248)
If I configure WAN1 or WAN2 or WAN sub-interface with the IP 192.168.0.98 this ip not work, I can't ping internali this IP, but if I configure other IP address range (97,99-101) my USG work well.
Some one has ideia about this?
This is my case.
We have a rang of WAN IPs (Ex: 192.168.0.96-255.255.255.248)
If I configure WAN1 or WAN2 or WAN sub-interface with the IP 192.168.0.98 this ip not work, I can't ping internali this IP, but if I configure other IP address range (97,99-101) my USG work well.
Some one has ideia about this?
0
All Replies
-
The mensage bellow is show when a ping the ip .98
ping: sendmsg: Operation not permitted
0 -
Hi @RaphaelOliveira,
For some ISP, some IP addresses are used for access link only, not for data link.
When you configure 192.168.0.98 in wan1, use the following command on web console to check the ping result.
Router# ping 8.8.8.8 interface wan1
Before entering the command, capture packets on wan1 interface and filter by icmp.
0
Categories
- All Categories
- 390 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 331 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 879 Nebula FAQ
- 414 Security FAQ
- 220 Switch FAQ
- 194 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 61 Security Highlight