USG310 port role mapping
Hello,
on the usg60/40/20 there was an easy way to map port roles to duplicated lan1 across multiple ports. On the USG310 there is no option for that. I tried to create a bridge and add ports into that bridge group but then when i try to assign dhcp for that bridge group it gives me an error message when trying to assign dhcp using the same ip scheme as my lan 1. Is there a way to have the bridge i created use dhcp from my lan 1 config?
on the usg60/40/20 there was an easy way to map port roles to duplicated lan1 across multiple ports. On the USG310 there is no option for that. I tried to create a bridge and add ports into that bridge group but then when i try to assign dhcp for that bridge group it gives me an error message when trying to assign dhcp using the same ip scheme as my lan 1. Is there a way to have the bridge i created use dhcp from my lan 1 config?
0
All Replies
-
Why not use a switch?
Give the ports for the bridge a non-usable IP like 127.255.255.1/255.255.255.252...127.255.255.5/255.255.255.252.
this should stop the error message when doing DHCP for the bridge.0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight