Zywall 100 lost configuration
Options
After power off my Zywall 100 lost last configuration and start with "last good". Because always after some changes I save config I try start Zywall with backup config: Zywall find some problems in it and back to "last good". How can I check what is wrong in this config?
0
All Replies
-
Hi @Leszek,
Connect the serial console between ZyWALL and one laptop.
Use the commands to apply your backup configuration file.
If it failed to apply the backup configuration file, you'll find the reason in "ERROR:".
Router# configure terminal
Router(config)# apply /conf/test_backup.conf
0 -
Hiwe tested it and finally there was no error on the terminal but new config did not load. There was a additional restart during loading new config and Zywall had old one "last good".But we found a solution: we use the load via HTTP with option "...ignoring errors" and it's working.
1
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 52 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight