How to optimize wireless performance on 2.4 GHz?
Suggestion 1: Configure the DCS of channel selection.
Suggestion 2: Separate the managed VLAN and SSID VLAN to avoid broadcast packet interfere the data packet transmit.
A large subnet increases broadcast and multicast traffic, which also raises the amount of packet collisions and reduces the airtime fairness rate to slow down the network.
Suggestion 3: Configure the channel width to 20 MHz on 2.4 GHz because there are more non-over lapping channels available when using 20 MHz.
suggestion 4: If AP has enough wireless coverage and signal, then you can adjust the multicast rate from 5.5 Mbps to 12 Mbps on the NXC controller.
Go to Configuration > Object > AP profile > Radio. Edit the radio profile of 2.4 GHz in Show Advanced Settings: Multicast Settings.
Suggestion 5: Enable the Signal threshold. It can avoid the station connect the AP with poor signal and get the low throughput. (The value suggestion like Station Signal Threshold: -70 dBm, Disassociated Station Threshold: -75dBm. The value is for reference. It is need to adjust in the real case.)
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 52 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight