How to Configure Device HA Pro

Zyxel_CooldiaZyxel_Cooldia Zyxel Official Agent Posts: 692  mod

The Device HA feature acts as a failover when one of the devices in the network is dead or can’t access the Internet. Therefore, this is a popular feature for network environments. In the previous firmware version, the USG supports AP (Activate-Passive/Master-Backup) mode. In V4.25, the Device HA feature is enhanced and named Device HA Pro.


In Device HA Pro, a “heartbeat link” is added for monitoring the interface status and synchronizing settings. Follow the steps below to deploy the Device HA Pro feature in your network environment.


Device HA Pro License

The Device HA Pro feature is license required. You must register both of your devices on the myZyXEL.com server first. Then make sure the Device HA Pro license is available on both of your devices.


Behavior of the Device HA Pro

The behavior of the Device HA Pro includes a heartbeat link to monitor the “activate” device’s interface status. If one of the monitored interfaces is dead or fails, the “passive” device’s status will become “activate”. (This means only 1 device’s status can be “activate” at a time.)

Be aware that the Device HA status of the devices might constantly change due to the network environment situation. In the current firmware design, Device HA Pro will not fallback when the primary device interface is working normally again.

 

Device-HA Pro Setting Screen

A.    Enable configuration provisioning on the activated device

This function is for the secondary device. If you are configuring the primary device, this function is unnecessary.

B.     Serial number of the licensed device for license synchronization

Entering the serial number of license from the myZyXEL.com server.

C.    Configure the Device HA Pro interface

Enter the management IP address of the active and passive devices. Also, enter the password for synchronizing configuration with each other.

D.    Monitoring Interfaces

Select the interfaces which you would like to monitor.

E.     Synchronization

Enable failover when one of the interfaces fails.



 

The Main Function of the Device HA Pro

 

Heartbeat Link

The heartbeat port is a new physical port on the device.

After you have enabled Device HA Pro, the devices will transmit multicast packets (UDP 694) to check each device’s status.

When the passive device is working properly, the system LED light will be on. Only the heartbeat port’s LED light can be on.

Suggestions

1.     Transfer all the licenses to the primary device. This helps to avoid the system from recounting licenses every time.

2.     Enable the connectivity check function on the monitored interfaces. When an interface doesn’t receive any response from the remote server for a certain period of time, the device will consider the interface status as fail. Then the Device HA Pro feature will change the status of the interface.


Sign In to comment.