Why can't I receive the SNMP trap when PD failure is detected in case of Auto PD recovery enabled?
Options
Zyxel小編 Lucious
Posts: 278 Zyxel Employee
Scenario:
Auto PD recovery feature is enabled in my GS1350 and PD failure on port 1 is detected.
I could see the event in syslog.
However, there is no trap record that can be found in SNMP server.
Am I missing something?
Setup Procedure:
In order to send trap correctly when PD failure is detected, the trap destination IP address must be assigned and "poe" option must be checked in trap groups.
In web-GUI, go to Management -> Access Control -> SNMP.
1. Assign your SNMP server IP for the trap destination and apply.
2. Go to Trap Group, check "poe" and apply.
Verification:
You can now both see syslog and SNMP trap when PD failure is detected.
Tagged:
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 74 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 333 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 198 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight