How to set VLAN setting for Link Aggregation in GS1900 series
Zyxel小編 Lucious
Posts: 278 Zyxel Employee
Scenario:
I have GS1900 series switches and have configured Link Aggregation group in switch 1 (port 1 & port 2 as trunk group LAG1). Now I want to put this trunk group into VLAN 100. How should I configure the VLAN setting?
Setup Procedure:
In GS1900 series, there will be trunk group (LAG1, LAG2, ...) shown in VLAN setting page.
Instead of configuring LAG1's member ports (port 1 & 2) respectively, you should directly configure the VLAN100 setting for LAG1
Note: The VLAN setting on member ports of the LAG group will be ignored. In this case, the VLAN setting of port 1 & 2 will not take effect.
Verification:
Connect a device to LAG 1 ports on GS1900, then you're able to see VLAN 100 in LAG 1 in MAC address table.
From the captured packet:
Tagged:
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight