USG1100 - How to receive an alert when WAN disconnects or reconnects?
I would like to receive an email alert when one of the WAN ports changes from ACTIVE to DEAD or from DEAD to ACTIVE from a connectivity check.
I went into log category setting for email server and changed Connectivity Check (inside Network) from Normal to Alert. This works fine for when the connectivity check fails and the port is set to DEAD. I receive an email. However, I do not get an email when the connectivity check starts working again and the port is set to ACTIVE. I do get a log entry.
It would be helpful to receive an email when the connection comes back up.
All Replies
-
Hi @imaohw
Now, we can only receive the email when the connective check fail, but there is no email when the session comes back.
Thanks for your feedback and we will put this enhancement into idea section for future evaluation.
0 -
@Zyxel_Jerry - thanks for the follow up.
The way it works now; I know there was a failure which is very helpful. Concerned, I then log in to check on the status only to mostly find that the issue has resolved itself and I didn't need to worry.
An alert on restoration of the connection would reduce unnecessary panic.
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight