Cannot register VPN100 to Nebula Control Center
Tried to add a out-of-the-box VPN100 to Nebula Control Center, together with GS-1920v2 switches. Adding the switches using mac+serial number went smoothly, but when adding the mac+serial of the VPN100, Control Center says: 'model is not supported by NCC'.
Alternatively, I hooked the VPN100 to the network/WAN and used manual setup to quickly configure WAN+LAN addresses. The video on the logon page to add the device to NCC is not current anymore, so I'm basically stuck.
What can I do to solve this?