Urgent FTP from internal to FQDN
Options
IntelliSoft
Posts: 5
Hey
I have a USG110
It is bound to an DynDns account.
I have created a policy control, which goes from "any" to "LAN1", Destination = IP of FTP Server, Service = FTP
When I am out of my office I can connect without any problem to my FTP by using the FQDN.
But when I am in my office and have an internal IP, then I can't connect to the FTP by using the FQDN anymore.
How can I get this working? - THX a lot in advance
I have a USG110
It is bound to an DynDns account.
I have created a policy control, which goes from "any" to "LAN1", Destination = IP of FTP Server, Service = FTP
When I am out of my office I can connect without any problem to my FTP by using the FQDN.
But when I am in my office and have an internal IP, then I can't connect to the FTP by using the FQDN anymore.
How can I get this working? - THX a lot in advance
0
Accepted Solution
-
Found the solution. - I have had to enable the NAT Loopback. - Then it works fine - THX0
All Replies
-
Found the solution. - I have had to enable the NAT Loopback. - Then it works fine - THX0
-
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 52 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight