What is the procedure to construct the WDS between the standalone APs?
Zyxel_Joslyn
Posts: 360 Zyxel Employee
0. Connect all APs to the switch through Ethernet cable
1. Go to CONFIGURATION > Network > IP Setting, and configure all the APs with static IP addresses.
2. Go to CONFIGURATION > Object > WDS Profile > WDS, and configure the WDS SSID. Also confirm the WDS SSID and Pre-Shared Key on all APs are the same.
3. (On root AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Root AP", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
4. (On repeater AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Repeater", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
5. Remove the cable line of the Repeater AP, and boot it up in the location you'd like to.
Verification
1. (On Root AP) Go to MONITOR > Wireless > WDS Downlink Info, and you will see the Repeater AP MAC address.
2. (On Repeater AP) Go to MONITOR > Wireless > WDS Uplink Info, and you will see the Root AP MAC address.
1. Go to CONFIGURATION > Network > IP Setting, and configure all the APs with static IP addresses.
2. Go to CONFIGURATION > Object > WDS Profile > WDS, and configure the WDS SSID. Also confirm the WDS SSID and Pre-Shared Key on all APs are the same.
3. (On root AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Root AP", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
4. (On repeater AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Repeater", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
5. Remove the cable line of the Repeater AP, and boot it up in the location you'd like to.
Verification
1. (On Root AP) Go to MONITOR > Wireless > WDS Downlink Info, and you will see the Repeater AP MAC address.
2. (On Repeater AP) Go to MONITOR > Wireless > WDS Uplink Info, and you will see the Root AP MAC address.
Tagged:
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 832 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight