VPN2S Site to Site VPN (full tunnel mode)

mumma
mumma Posts: 2
First Comment
edited April 2021 in Security
Hi

I've set up a site-to-site VPN between Site A (local Subnet 192.168.21.0) and Site B (local Subnet 192.168.51.0). Both Sites run a ZyWALL VPN 2S with latest firmware. I can access Subnet 192.168.21.0 from Site B. But I wan't all traffic from Site B to pass Site A.

I tried the Option "Full tunnel (Force all traffic to cross the VPN tunnel to the remote site)". The result is no internet acess from Site B.

What do I miss?

Both ZyWALLs are behind NAT.

Screen Shot Site B with "Full tunnel" unchecked (uses local Gateway for internet access). Tried check the option -> no internet access.

Cheers

Accepted Solution

All Replies

  • mumma
    mumma Posts: 2
    First Comment
    Hi Emily, thanks for the response! Not the response I was hoping for but it answers my question;-) For my use case that would be a great feature. Ideas section sounds good. Thanks!

Security Highlight