[NEBULA] Site-to-Site VPN. Two NSG50 connected and tunnel established but now what?
Options
I have two NSG50 units for a headquarters and branch1. I've established a site-to-site vpn using Nebula. Able to ping headquarters Gateway, AP, and printers on site. Able to access web-interfaces for printers. Was not able to ping target PC at headquarters. Not able to see shared network resources under Network on branch1 PC. What step(s) am I missing in Windows to make this work? Creating security policies and generating certificates?
0
Comments
-
Have you disable the firewall rule on windows? Maybe that's why there is no respond.
As I recall, you cannot find the shared folder in the network neighborhood, since their VPN tunnel doesn't allow broadcast traffic pass through the tunnel.
You can try to access via IP directly.2 -
If I disable the private network firewall I can ping each target PC, map network drives and printers by their IP address. Resolved!
0 -
Categories
- All Categories
- 390 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 331 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 879 Nebula FAQ
- 414 Security FAQ
- 220 Switch FAQ
- 194 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 61 Security Highlight